Oh, DIY master bathroom shower renovation saga, I have not forgotten thee.
Holy sh*t is it tedious. You gotta incessantly check for level every three damn seconds. Row after row after row after row....It feels like it's never ever ever gonna end!
Last we left off, I had finally finally finally gotten that floor drain and hex mosaic
floor tile down. Whew. The sense of relief that washed over me
(ahhh ha ha, shower pun)...that drain....that drain installation
plagued me.
So I was impatient to get rolling on the wall tile because that meant the
end was nearing. Righty-o!
But wait. I had to wait. Why? Because the tile mortar on
the floor was not set, like a week later. Omg. Yeah. Right?!
I stepped into the shower one day, felt a squish and a shift and I nearly
cried. No air movement in there and it was winter, not particularly
warm in the house.
Eventually it set, jeez louise, and I cheerleader'ed myself back into a
tiling tizzy.
Then, ha, I discovered what a pain in the a** subway tile is to install.
Oooooohmg. You wouldn't think, it's just a simple rectangle, but
it is a Pain In The A**.
Holy sh*t is it tedious. You gotta incessantly check for level every three damn seconds. Row after row after row after row....It feels like it's never ever ever gonna end!
Why did I do this to myself?! Haha, glutton for punishment I suppose!
So, designers, friends, sure subway tile is timelessly attractive, it's also
quite affordable, but know you are psychologically torturing your installer
by spec'ing it. Sleep well, *cough.*
All right. Let's do this.
All right. Let's do this.
Ok!! First I installed those uh what are they, metal tile edge* thingies....ah, no, not plural, just one as I decided sitting on the
can gazing at that wall one day that ending the shower tile at the pocket door was probably going to look bizarre as I planned to tile to the
ceiling.
Sooo, I opted to tile that entire wall. Yes, I am ridiculous.
I nearly went further than that...
|
|
Gosh dang it! So close and yet so far! Just butt-join
a shorter piece and hope no one sees the seam. See how to cut it here. |
Those tile edges are only eight feet long so I had
a connection dilemma. I figured if the seam was near the ceiling,
that'd be less noticeable. Indeed, this is true.
Easy install, just line it up where you want it and screw it in.
Screws are better as nails could wiggle back out.
As you remember, I bought some
3x12 glossy white subway tile
from the ol' Floor & Decor joint. Going for contrast against the
matte floor.
Right...so on the wide wall, I found center and drew a vertical line.
Next I offset six inches on either side (double check your actual
tile dimensions), drew two more vertical lines. These were my
guidelines for the entire installation.
Because the shower base is slope-y, as it should be, you can't rely on
your floor for a level first course start. At first I started smack
center which was right for my layout but wrong due to that slope.
Doh, oops.
See, your very first course of tile is your most important course.
Yeah no pressure. If it's off, the whole thing is off and once
it's dry, it's set and you're screwed. Take your time and get it
right.
Granted, per usual, I started late in the day which is always a bad idea.
But, I forced my brain to patiently take its time.
|
| Lots going on here. Refer back while reading the info sprinkled throughout. |
Hence, I went from the corners and figured out the first horizontal line to
follow, sparking up
the spiffy laser level to show me the light.
Thank holy goodness gracious for that spiffy DeWalt laser level, thank you Janette. If you don't have one, you can certainly get one* but you can also go with a regular level.
Oh, the layout, yeah, I did figure that in advance
using AutoCAD. I know, I'm sorry, I keep using tools you might not have.
But, you can map this out by hand too.
And trust me, truuuust me, I considered so many different versions:
half offset, a third offset, no offset, all those but vertically, a
pattern....I made myself nuts. In the end, I went with plain old
typical.
Do I regret it? A little bit. On the whole, I stress because
there's always another way and what if the other way had been better.
These what-if issues torment me constantly.
Constantly. How I get anything accomplished, I dunno.
Sigh, heh.
Ok. End of day one and I've got one row stuck. I was feelin'
good, real good. This was progress and I like progress. A lot.
|
|
Iiiii know, hardly seems any progress but this took a very long
time. Most important course, ya know. |
And again, yes, I used that laughably expensive pre-mixed tile mortar
because I wanted to hold onto some semblance of sanity.
Beeecause, who knew, there'd be a ton of cutting involved. hahaha,
it's just a darn freakin' shower with straight walls but man, it's amazing
how much cutting still follows.
Beeecause, with each corner turn, I cut the tile to fit the long wall,
leaving the remainder to turn the corner onto the short wall. Nearly
every cut had to be custom because the shower framing
is
freakin’ not square
as I discovered. This is important info later.
Yeah! Omg. Sanity tested.
Day two, day three, day one hundred and seventy four ninety two trillion,
more rows. Do not forget to buy those
tile spacers,* by the way.
|
|
Day two end. Yeah, no joke. I didn't have a lot of
available free time to do this either. Mike was getting anxious
now, "when ya gonna be done, babe?" Although, he still claimed
he was staying in
the hall bath. |
|
|
Ah, here's another view on how those three vertical lines were my
guidelines. |
Then I reached the niche. What a what-if non-regret.
The vertical wall surface, I did the hex mosaic to break things up visually
then lined the inside with the subway. Got some
pencil tiles* from Menards, did a frame around it. Lots of
math. Ok, woot, moving on.
Until...
|
| Don't forget to angle those bottom tiles so water drains into the shower, doesn't pool there. Do pre-made shower niches* come pre-angled? I dunno! |
My math was incorrect.
In retrospect, learning is 20/20 right? If I ever do this again, if, I
will wait to cut out the niche once tile starts up the wall to ensure math
accuracy.
I ended up with what I loathe seeing: the field tile did not
line up.
|
|
Dooooooooohhhhhh I was so upset with myself!! Oh
math. Why must you torture me so. |
I, therefore too, was forced to extra suffer for it because cutting those
tiles in miniscule slivers was a bitch and a half and then some. Lots
of tiles and spirits were broken.
|
|
Those two tiles at the bottom surrounding the niche took forever and
day. Forever. |
In retrospect, some of my wistfulness, if you will, stems from doing this
tile work for the next owner, not us. Black
tile or a spike of
yellow
or an atypical layout, that’s me; a white brick layout, not really me.
Sigh. Heh. Alas. It's fine. I don't hate it.
|
| So. Many. Tiles. |
Sorry to run on kind of a bummer note! Please come vote for me (and
share as it’s a one-time vote) in the
Amara Interior Blog Awards
(voting has ended) anyway, please! Mwah, thank you!
Have you just joined this master bathroom shower saga? Start the story here! Or, jump to the
next in the series here!
*The laser levels, tile spacers, pencil tiles, and pre-fabricated shower
niches are Amazon affiliate links. Mwah, thanks! Please see the
"boring stuff" tab for more info.










Post a Comment
Please no spam or links, thanks!